Science · 51 calculators
Battery Life Calculator
Battery life in hours is the stored energy divided by the power the load draws. Amp hours give the charge, volts multiply that into watt hours, and the load in watts sets how fast it drains.
Last updated
Runtime in hours
2
- Runtime at your depth of discharge
- 1.6
- Stored energy in watt hours
- 1,200
- Load current in amps
- 50
- Peukert corrected runtime
- 1.0024
Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.
The formula this calculator uses
runtime hours = amp hours x volts / watts
- Ah
- The capacity in amp hours
- V
- The pack voltage in volts
- W
- The load in watts
- DoD
- The usable depth of discharge
How to check the result by hand
- 1
Convert capacity into watt hours
Multiply the amp hour rating by the nominal voltage. A 100 amp hour pack at twelve volts stores 1200 watt hours.
- 2
Divide by the load in watts
1200 watt hours divided by a 600 watt load is two hours, which is the ideal runtime over the full capacity.
- 3
Apply the depth of discharge
At eighty percent usable capacity the same pack delivers one and a half hours, because twenty percent of the charge is held back.
- 4
Check the discharge rate
Six hundred watts at twelve volts is fifty amperes, which is half the pack's rating. Lead acid loses usable capacity at that rate, which the Peukert figure reflects.
- 5
Add inverter losses if any
If the load runs from an inverter, divide the runtime by the inverter efficiency. At ninety percent efficiency the two hour figure becomes one and a half hours even at full discharge.
Common Questions
How does the Battery Life Calculator work?
Multiply the capacity in amp hours by the pack voltage to get watt hours, then divide by the load in watts. A 100 amp hour 12 volt pack holds 1200 watt hours, so a 600 watt load runs for two hours. Drawing only half the charge cuts that to one and a half hours.
What do I need to enter in the Battery Life Calculator?
It takes 4 inputs: Capacity, Pack voltage, Load, Depth of discharge (percent). Fields that expect a unit say so next to the label.
Where does Runtime in hours come from?
It comes from runtime hours = amp hours x volts / watts — the ideal runtime before depth of discharge and rate effects.
What is the most common mistake with the Battery Life Calculator?
Reading amp hours as watt hours. Amp hours are charge at a particular voltage. A 100 amp hour pack is only 3600 watt hours at thirty six volts and 1200 watt hours at twelve volts.
For worked examples, common mistakes and the limits of this formula, read the full How To Calculate Battery Life page.
