Math · 61 calculators
Surface Area Of A Cylinder Calculator
A cylinder is the easiest curved solid to understand, because unrolling its side turns it into a plain rectangle whose width is the circle's circumference.
Last updated
Total surface area
245.0442
- Curved surface area
- 188.4956
- Area of both ends
- 56.5487
- Volume
- 282.7433
Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.
The formula this calculator uses
surface area = 2 x pi x r x h + 2 x pi x r^2
- A
- Total surface area including both ends
- r
- Radius of the circular base
- h
- Height of the cylinder
How to check the result by hand
- 1
Find the radius and the height
Halve the diameter if that is what you measured. Both measurements must be in the same unit before anything is multiplied.
- 2
Work out the circumference of the base
Two pi r, which for a radius of three is about 18.85. This becomes the width of the rectangle you get by unrolling the side.
- 3
Multiply by the height for the curved area
18.85 times ten is 188.4956. This is the side alone, which is what you need for a label or for painting a pipe.
- 4
Add the two circular ends
Each end is pi r squared, about 28.2743, so the pair adds 56.5487. The running total becomes 245.0442.
- 5
Decide whether the ends belong
An open tube has no ends, so the answer is the curved area alone. A closed can needs both, and a can with one open end needs just one.
Common Questions
How does the Surface Area Of A Cylinder Calculator work?
The curved side is two pi r h, and the two flat ends add another two pi r squared. A cylinder of radius three and height ten has a curved area of 188.4956 and a total surface area of 245.0442.
What do I need to enter in the Surface Area Of A Cylinder Calculator?
It takes 2 inputs: Radius, Height. Fields that expect a unit say so next to the label.
Where does Total surface area come from?
It comes from A = 2 x pi x r x h — the unrolled side, which is a rectangle of width two pi r and height h.
What is the most common mistake with the Surface Area Of A Cylinder Calculator?
Using the diameter instead of the radius. The radius is half the diameter and it appears twice in the end area, so the error compounds. Using the diameter makes the ends four times too large and the side twice too large.
For worked examples, common mistakes and the limits of this formula, read the full How To Calculate The Surface Area Of A Cylinder page.
