Math · 61 calculators
Volume Of A Cylinder Calculator
Cylinder volume is the area of the circular base multiplied by the height. Nearly every wrong answer comes from one of two places: a diameter used where a radius belongs, or units that were never made consistent before being cubed.
Last updated
Volume of the cylinder
282.7433
- Area of the circular base
- 28.2743
- Area of the curved side
- 188.4956
- Total surface area including both ends
- 245.0442
- Diameter
- 6
Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.
The formula this calculator uses
V = pi x r^2 x h
- r
- Radius of the circular base — half the diameter
- h
- Perpendicular height between the two circular faces
- pi
- About 3.141592653589793, the ratio of circumference to diameter
- d
- Diameter, equal to 2r, used in the alternative form
- V
- Volume, in cubic units, equal to pi r squared h
How to check the result by hand
- 1
Decide whether you hold a radius or a diameter
A radius runs centre to edge; a diameter runs edge to edge through the centre. Packaging, pipes and drums are almost always quoted by diameter, so halve it before touching anything else. If the diameter is 6, the radius is 3.
- 2
Square the radius, then multiply by pi
This gives the base area. For a radius of 3, squaring gives 9 and multiplying by pi gives 28.27433388. Keep pi at full precision here and round nothing yet.
- 3
Multiply the base area by the perpendicular height
For a height of 10, that is 28.27433388 times 10, giving 282.74333882. The height enters only once, which is why it affects the result far less dramatically than the radius does.
- 4
Make the units consistent and state them cubed
Both lengths must share a unit before you multiply. Metres give cubic metres, centimetres give cubic centimetres, and one cubic metre is 1000 litres. Converting afterwards means cubing the length factor, not just applying it.
- 5
Sanity-check by doubling the radius
A radius of 6 with the same height gives 1130.97335529, exactly four times 282.74333882. If your check doubles rather than quadruples, you have almost certainly used a diameter somewhere it did not belong.
Common Questions
How does the Volume Of A Cylinder Calculator work?
Square the radius, multiply that by pi, then multiply by the height. A radius of 3 with a height of 10 gives a base area of 28.27433388 and a volume of 282.74333882, alongside a curved side of 188.49555922 and a total surface area of 245.04422698. Doubling the radius to 6 while leaving the height at 10 gives 1130.97335529, exactly four times as much, because the radius is squared and the height is not.
What do I need to enter in the Volume Of A Cylinder Calculator?
It takes 2 inputs: Radius, Height. Fields that expect a unit say so next to the label.
Where does Volume of the cylinder come from?
It comes from V = pi x r^2 x h — the standard form: square the radius, multiply by pi to get the base area, then multiply by the height. Only the radius is squared.
What is the most common mistake with the Volume Of A Cylinder Calculator?
Using the diameter as if it were the radius. Because the radius is squared, this multiplies the answer by four rather than by two. Putting a diameter of 6 into pi r squared h gives 1130.97335529 instead of the correct 282.74333882. Halve first, or use the diameter form deliberately.
For worked examples, common mistakes and the limits of this formula, read the full How To Calculate The Volume Of A Cylinder page.
