CCalclabhub

Everyday Life · 57 calculators

Deck Boards Needed Calculator

A deck is covered one row at a time. Work out how many rows fit across the width, multiply by the length, and you have the linear feet to buy.

Last updated

Boards needed

29

Deck area
192
Rows of boards
26
Linear feet with waste
457.6
Area covered by one board
7.5
Boards before waste
26

Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.

The formula this calculator uses

rows = ceil(12 x deck width / (board width + gap)), boards = ceil(rows x deck length x (1 + waste) / board length)

rows
The number of boards running across the deck width
gap
The spacing left between boards for drainage
deck length
The run the boards are laid along
waste
Extra allowance for cuts, defects and diagonal layouts

How to check the result by hand

  1. 1

    Add the gap to the board width

    A 5.5 inch board with a one eighth inch gap occupies 5.625 inches. Skipping the gap understates the deck by about half a board over a twelve foot width.

  2. 2

    Divide the deck width in inches

    Twelve feet is 144 inches, and 144 divided by 5.625 is 25.6, which rounds up to 26 rows of decking.

  3. 3

    Multiply by the deck length for linear feet

    Twenty six rows across a 16 foot deck is 416 linear feet, and ten percent for cuts takes that to 457.6 feet of board.

  4. 4

    Convert to the lengths you buy

    457.6 feet divided by 16 foot boards is 28.6, so 29 boards go on the order. Before waste the deck needs 26, which matches the row count.

Common Questions

How does the Deck Boards Needed Calculator work?

Add the gap to the board width, divide the deck width in inches by that number, and round up. A 16 by 12 foot deck takes 26 rows, which is 457.6 linear feet with waste, or 29 boards of 16 feet.

What do I need to enter in the Deck Boards Needed Calculator?

It takes 6 inputs: Deck length, Deck width, Board width, Gap between boards, Board length, Waste allowance (percent). Fields that expect a unit say so next to the label.

Where does Boards needed come from?

It comes from rows = ceil(12 x deck width / (board width + gap)) — the number of boards that fit side by side across the deck.

What is the most common mistake with the Deck Boards Needed Calculator?

Forgetting the gap between boards. Using 5.5 instead of 5.625 inches gives 26.18 rows instead of 25.6 and quietly shortens the order once rounding is applied.

For worked examples, common mistakes and the limits of this formula, read the full How To Calculate Deck Boards Needed page.