Science · 51 calculators
Dilution Calculator
Diluting a solution adds solvent without changing how much solute is present. That single fact gives one equation relating the stock solution to the dilute one.
Last updated
Stock volume needed
10
- Diluent volume
- 90
- Dilution factor
- 10
- Stock as a share of the final volume
- 10.00%
Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.
The formula this calculator uses
C1 x V1 = C2 x V2
- C1
- Concentration of the stock solution you are starting with
- V1
- Volume of stock solution you need to measure out
- C2
- Concentration you want to end up with
- V2
- Final volume of the diluted solution
How to check the result by hand
- 1
Write down the stock concentration and the one you want
Call the stock C1 and the target C2, and make sure both are in the same unit. Five molar stock diluted to 0.5 molar is a clear pair; mixing molarity with millimolar is not.
- 2
Fix the final volume you want to prepare
This is V2, the total volume of the finished solution including the solvent. Wanting 100 millilitres of dilute solution means V2 is 100, not 90.
- 3
Solve for the stock volume
Multiply C2 by V2 and divide by C1. Half a mole per litre times 100 millilitres, divided by 5 moles per litre, gives 10 millilitres of stock.
- 4
Subtract to find the diluent
Take the stock volume away from the final volume. Ninety millilitres of solvent brings 10 millilitres up to the 100 millilitres you wanted. Adding 100 millilitres of solvent instead would overshoot.
- 5
Check with the dilution factor
Divide the stock concentration by the final one. Five divided by 0.5 is 10, so this is a tenfold dilution, and the final volume divided by the stock volume should also come to 10. Both routes agreeing is a good sign the arithmetic is right.
Common Questions
How does the Dilution Calculator work?
The moles of solute do not change when you add solvent, so the concentration times the volume is the same before and after. To make 100 millilitres of a 0.5 molar solution from 5 molar stock you need 10 millilitres of stock, 90 millilitres of diluent, and the dilution factor is 10.
What do I need to enter in the Dilution Calculator?
It takes 3 inputs: Stock concentration, Target concentration, Final volume. Fields that expect a unit say so next to the label.
Where does Stock volume needed come from?
It comes from C1 x V1 = C2 x V2 — the moles of solute are conserved, so concentration times volume is unchanged by adding solvent.
What is the most common mistake with the Dilution Calculator?
Treating the diluent volume as the final volume. The final volume is stock plus diluent, not diluent alone. Adding 100 millilitres of solvent to 10 millilitres of stock produces 110 millilitres of a weaker solution than intended, and the error is invisible unless you check the dilution factor.
For worked examples, common mistakes and the limits of this formula, read the full How To Calculate Dilution page.
