Science · 51 calculators
Percent Error Calculator
Percent error turns the gap between a measurement and an accepted value into a single number that can be compared across experiments of different sizes.
Last updated
Absolute error
5
- Percent error
- 5.00%
- Percent difference between the two
- 4.88%
- Signed difference
- 5
Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.
The formula this calculator uses
percent error = |experimental - theoretical| / |theoretical| x 100
- E
- Experimental value, what you actually measured
- T
- Theoretical value, the accepted or true figure
- |E - T|
- Absolute error, the size of the gap ignoring direction
- % error
- The absolute error as a percentage of the accepted value
How to check the result by hand
- 1
Identify which value is the accepted one
The accepted value is the denominator, so deciding which is which changes the answer. A known standard, a textbook constant or a certificate value is the accepted figure; your reading is the experimental one.
- 2
Subtract to find the absolute error
Take the difference and drop the sign. Reading 105 against an accepted 100 gives 5, and reading 95 against 100 also gives 5, because both are equally far from the truth.
- 3
Divide by the accepted value
Five divided by 100 is 0.05. This is the relative error, and it is the quantity to use if you are going to carry the number through further algebra.
- 4
Multiply by 100 for the percentage
0.05 becomes 5 percent. The percentage is the version to report, because it is comparable across experiments with different units and different magnitudes.
- 5
Report the percent difference as well if there is no true value
When comparing two measurements rather than a measurement against a standard, divide by the average of the two instead. For 105 and 100 that is 5 divided by 102.5, which gives 0.04878048780487805, slightly smaller than the percent error.
Common Questions
How does the Percent Error Calculator work?
Subtract the accepted value from the measured one, take the absolute value so the sign does not matter, divide by the accepted value, and multiply by 100. A reading of 105 against an accepted 100 has an absolute error of 5 and a percent error of 5 percent, while the percent difference between the two figures is 0.04878048780487805.
What do I need to enter in the Percent Error Calculator?
It takes 2 inputs: Experimental value, Theoretical value. Fields that expect a unit say so next to the label.
Where does Absolute error come from?
It comes from percent error = |E - T| / |T| x 100 — the absolute gap divided by the accepted value, expressed as a percentage.
What is the most common mistake with the Percent Error Calculator?
Dividing by the measured value instead of the accepted one. The denominator is the accepted value, because the error is measured against the truth rather than against the reading. Swapping them changes the answer, and it also breaks comparability between experiments that share the same standard.
For worked examples, common mistakes and the limits of this formula, read the full How To Calculate Percent Error page.
