CCalclabhub

Math · 61 calculators

Area Of A Sector Calculator

A sector is the wedge-shaped piece of a circle bounded by two radii and the arc between them. Its area is a simple fraction of the whole circle, with the fraction set by the central angle.

Last updated

Sector area

19.635

Arc length
7.854
Share of the full circle
25.00%
Full circle area
78.5398
Central angle in radians
1.5708

Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.

The formula this calculator uses

sector area = (angle / 360) x pi x r^2, or 0.5 x r^2 x theta in radians

r
The radius of the circle
angle
The central angle, in degrees
theta
The same angle in radians
sector area
The wedge-shaped area

How to check the result by hand

  1. 1

    Read the central angle

    The angle must be the one at the centre between the two radii, not an angle somewhere on the circle. A 90 degree angle cuts a quarter of the circle.

  2. 2

    Convert to radians if you prefer the short formula

    Multiply the degrees by pi and divide by 180. Ninety degrees becomes 1.5707963267948966 radians.

  3. 3

    Compute the full circle area

    Pi times the radius squared. For a radius of 5 that is 78.53981633974483, which is the total you are taking a fraction of.

  4. 4

    Take the fraction

    Divide the angle by 360 and multiply by the circle area, or use 0.5 times the radius squared times the radians. Either route gives 19.634954084936208.

  5. 5

    Check against the full circle

    The sector must be smaller than the whole circle, and the fractions of all your sectors must add to one. A quarter circle of radius 5 is exactly 19.634954084936208.

Common Questions

How does the Area Of A Sector Calculator work?

Convert the angle to radians, then take half the radius squared times that angle. A radius of 5 with a 90 degree angle gives 19.634954084936208 of area, an arc of 7.853981633974483, and a quarter of the full circle area of 78.53981633974483.

What do I need to enter in the Area Of A Sector Calculator?

It takes 2 inputs: Radius, Central angle. Fields that expect a unit say so next to the label.

Where does Sector area come from?

It comes from sector area = (angle / 360) x pi x r^2 — the wedge's share of the circle, taken straight from the angle as a fraction of a full turn.

What is the most common mistake with the Area Of A Sector Calculator?

Using the width of the wedge instead of the central angle. The formula needs the angle at the centre between the two radii. An angle measured somewhere else on the circle gives a completely different fraction.

For worked examples, common mistakes and the limits of this formula, read the full How To Calculate The Area Of A Sector page.