CCalclabhub

Everyday Life · 57 calculators

Shingles Needed Calculator

Shingle quantity starts from the roof area, not the floor area. Steeper roofs cover more surface, so the pitch multiplier has to be applied before anything is ordered.

Last updated

Sloped roof area

1,341.64

Squares needed
14.76
Bundles needed
45
Underlayment rolls
4
Pitch multiplier
1.118

Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.

The formula this calculator uses

squares = roof length x roof width x pitch multiplier x (1 + waste) / 100

squares
Roofing area in units of 100 square feet
bundles
Three bundles make one square for standard shingles
pitch multiplier
The square root of one plus pitch over twelve squared
waste
An allowance for cuts, starter courses and ridge caps

How to check the result by hand

  1. 1

    Measure the footprint

    A 40 by 30 foot roof has a footprint of 1200 square feet. For a gable roof this is simply the length times the width at the eaves.

  2. 2

    Apply the pitch multiplier

    At 6/12 pitch the multiplier is the square root of one plus 0.25, which is 1.118. The sloped area is 1200 times 1.118, which is 1341.64 square feet.

  3. 3

    Add the waste allowance

    Ten percent waste brings 1341.64 to 1475.8 square feet. Complex roofs with valleys and dormers should use fifteen percent instead.

  4. 4

    Convert to squares and bundles

    1475.8 divided by 100 is 14.76 squares, and at three bundles per square that is 44.27 bundles, so order 45 bundles. Underlayment at 400 square feet per roll needs four rolls.

Common Questions

How does the Shingles Needed Calculator work?

Multiply the footprint by the pitch multiplier, add a waste allowance, then divide by 100 to get squares. A 40 by 30 foot roof at 6/12 pitch needs 14.76 squares, which is 45 bundles at three bundles per square.

What do I need to enter in the Shingles Needed Calculator?

It takes 4 inputs: Roof length, Roof width, Pitch rise, Waste allowance (percent). Fields that expect a unit say so next to the label.

Where does Sloped roof area come from?

It comes from roof area = length x width x pitch multiplier — the pitch multiplier converts the plan area into the sloped surface area.

What is the most common mistake with the Shingles Needed Calculator?

Ordering shingles for the floor area. The sloped roof is always larger than the plan. At 6/12 pitch the difference is 11.8 percent, so ordering 12 squares for a 1200 square foot footprint leaves the job short.

For worked examples, common mistakes and the limits of this formula, read the full How To Calculate Shingles Needed page.