CCalclabhub

Math · 61 calculators

Z-Score Calculator

A z-score restates a value as how many standard deviations it sits from the mean. That rescaling removes the original units, which is exactly what lets you compare things that were never commensurable.

Last updated

Z-score

1

Distance from the mean (original units)
10
Distance ignoring direction (|z|)
1

Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.

The formula this calculator uses

z = (x - mean) / standard deviation

x
The value you are standardising
mean
Average of the distribution the value came from
SD (sigma)
Standard deviation of that same distribution
z
Signed distance from the mean, measured in SD units

How to check the result by hand

  1. 1

    Fix the reference distribution first

    Decide what population the value belongs to. The mean and standard deviation must both describe that same population, or the result describes nothing.

  2. 2

    Subtract the mean

    x - mean gives the signed deviation in original units. Here 85 - 75 = 10, so the value sits ten points above average. Keep the sign; it is the entire directional content.

  3. 3

    Divide by the standard deviation

    10 / 10 = 1.0. Read the result as "one standard deviation above the mean" rather than as a bare number, which keeps the interpretation attached to the figure.

  4. 4

    Sanity-check the magnitude

    Most ordinary observations land between -2 and 2. Anything beyond roughly 3 is genuinely rare in bell-shaped data, and beyond that you should suspect a mismatch of distribution before celebrating a finding.

  5. 5

    State whether normality is being assumed

    If you go on to quote a percentile, that step needs the bell curve. Say so explicitly, because the z-score by itself justifies no such statement.

Common Questions

How does the Z-Score Calculator work?

Subtract the mean from your value, then divide by the standard deviation. A mark of 85 in a distribution averaging 75 with a standard deviation of 10 sits 10 points above the mean, which is 1.0 standard deviations, giving z = 1. Positive means above average, negative below, zero exactly at the centre — and because the units cancel, that single number can be compared against a score from a completely different test or population.

What do I need to enter in the Z-Score Calculator?

It takes 3 inputs: Value to standardise (x), Mean of the distribution, Standard deviation. Fields that expect a unit say so next to the label.

Where does Z-score come from?

It comes from z = (x - mean) / SD — recentre then rescale. The result carries no units because the numerator and denominator share them.

What is the most common mistake with the Z-Score Calculator?

Treating z as a percentile without assuming a shape. Converting z into "better than X percent" requires the normal distribution. The z-score alone rescales; it does not tell you how much of the population sits below.

For worked examples, common mistakes and the limits of this formula, read the full How To Calculate A Z-Score page.