CCalclabhub

Geometry

Curved side and total surface area

Both come from the same inputs as the volume but are measured in square units. The two ends are the base area counted twice.

Last updated

The Formula

Lateral A = 2 pi r h, total A = 2 pi r h + 2 pi r^2

Both come from the same inputs as the volume but are measured in square units. The two ends are the base area counted twice.

SymbolMeaning
Lateral AArea of the curved side only
Total ACurved side plus both circular ends
rRadius shared with the volume formula

What Each Symbol Means

Lateral Asquare units

Area of the curved side only

Unrolls into a rectangle of width 2 pi r and height h.

Total Asquare units

Curved side plus both circular ends

The quantity you need for material or paint estimates.

rlength

Radius shared with the volume formula

Same value as in V = pi r squared h; never substitute the diameter here.

See It Worked With Real Numbers

A formula on its own does not tell you which number goes where. The how to calculate the volume of a cylinder page applies this equation to a concrete case, shows every intermediate step, and names the mistakes that produce a wrong answer even when the algebra is right.

Where This Formula Appears

This equation is the working core of How To Calculate The Volume Of A Cylinder, filed under Math. Every number the guide produces comes from substituting into this one line.

Common Questions

What is the formula for Curved side and total surface area?

The formula for Curved side and total surface area is Lateral A = 2 pi r h, total A = 2 pi r h + 2 pi r^2. Both come from the same inputs as the volume but are measured in square units. The two ends are the base area counted twice.

What does each symbol in Curved side and total surface area stand for?

Lateral A is area of the curved side only; Total A is curved side plus both circular ends; r is radius shared with the volume formula.

What units should I use with Curved side and total surface area?

Substitute Lateral A in square units, Total A in square units, r in length. Convert every input to those units before you start, because the equation only returns the right answer when the units on both sides agree.

What is a common mistake when using Curved side and total surface area?

Reporting units that were never cubed. Volume is cubic, and conversions cube the length factor: one cubic metre is 1000 litres and a million cubic centimetres, not a hundred. A radius in centimetres paired with a height in metres produces a figure wrong by a large power of ten.